※ 仕様・納期・価格等については弊社までお気軽にお問い合わせください。
※ また, このHPに紹介されている製品以外で, 取り扱い可能な製品もございます。
詳細は弊社までお問い合わせください。
照度計, 紫外線計測, 紫外線照度計
UVA, UVB, UVI(紫外線指数)を計測
英国 Skye Instruments 社製
Skye Instruments社製照度計は,
以下の"Sensor"と"Meter"を用意しています
Sensor: 紫外線計測に特化(UV-A, UV-B, UV-Iをクリックすると仕様に移動します)
- UV-A (315nm-380nm), 波長応答, 仕様
- UV-B (280nm-315nm), 波長応答, 仕様
- UV-I (280nm-315nm, 紫外線指数, Erythema 紅はん), 波長応答, 仕様
Meter: データログ機能付き, またはシンプルな照度表示機能
多チャンネル入力に対応(クリックするとMeter仕様に移動します)
UV-A(315nm-380nm)用センサー形状および波長応答
(写真および画像をクリックすると拡大します)
SPECIFICATIONS | |
Dimensions | phi 34 x 69 mm |
Weight | 200g (with 3m cable) |
Construction | Anodised black aluminium sealed to IP68 Submersible to 4m |
Cable | Screened cable 7-1-4C miiltary specification |
Sensor | Cosine corrected head Specially formulated diffuser |
Detector | GaAsP photodiode |
Filters | Optical glass |
Spectral response (1) | 315nm - 380nm |
Working range (2) | 0-100W/m2 |
Output signal | 0-1V |
Sensitivity | 10mV/W/m2 |
Thermal drift of output (-20 to +50 deg C) | 0.025mV/deg C max |
Zero offset range (each sensor is individually calibrated) |
+/-2 mV |
Thermal drift of zero offset (-20deg C to +50deg C) |
typically 0.01mV/deg C |
Ouput impedance | 500 ohm |
Power supply | 5-15V |
Linearity (0-1V with 9V power supply) | Better than 1% |
Absolute calibration error (3) | typ. <3%, 5% max. |
Cosine error (4) | 3% |
Azimuth error (5) | <1% |
Temperature coefficient | +/-0.2%/deg C |
Longterm stability (6) | +/-2% |
Response time (7) | Better than 10ms |
Operating range | -30 to + 60deg C, 0-100% RH |
NOTES ON SPECIFICATIONS |
(1) FWHM or 50% transmission (2) All Skye sensors will work at levels of irradiance well above that found in terrestrial sunlight conditions, room or growth chamber lighting (3) Main source of this error is uncertainty of calibration of Reference Lamp. Skye calibration standards are directly traceable to N.P.L. standard references. (4) Cosine error to 80deg is typically 5% max. Figures shown are for normal use sources, e.g., sun plus sky, diffuse sun, growth chambers, etc. (5) Measured at 45deg elevation over 360deg (6) Maximum change in one year. Calibration check recommended at least every two years. Experience has shown that changes are typically much less than figures quoted (7) Times are generally less than the figure quoted, which is in nanoseconds. They may be slightly increased if long leads are fitted, or those of a higher capacity cable |
UV-B(280nm-315nm)用センサー形状および波長応答
(写真および画像をクリックすると拡大します)
SPECIFICATIONS | |
Dimensions | phi 34 x 69 mm |
Weight | 200g (with 3m cable) |
Construction | Anodised black aluminium sealed to IP68 Submersible to 4m |
Cable | Screened cable 7-1-4C miiltary specification |
Sensor | Cosine corrected head Specially formulated diffuser |
Detector | SiC Photodetector |
Filters | N/A |
Spectral response (1) | 280nm-315nm |
Working range (2) | 0-10W/m2 |
Output signal | 0-1V |
Sensitivity | 150mV/W/m2 |
Thermal drift of output (-20 to +50 deg C) | 0.075mV/deg C max |
Zero offset range (each sensor is individually calibrated) |
+/-1 mV |
Thermal drift of zero offset (-20deg C to +50deg C) |
typically 0.03 mV/deg C |
Ouput impedance | 500 ohm |
Power supply | 5-15V |
Linearity (0-1V with 9V power supply) | Better than 1% |
Absolute calibration error (3) | typ. <3%, 5% max. |
Cosine error (4) | 3% |
Azimuth error (5) | <1% |
Temperature coefficient | +/-0.2%/deg C |
Longterm stability (6) | +/-2% |
Response time (7) | Better than 10ms |
Operating range | -30 to +60deg C, 0-100% RH |
NOTES ON SPECIFICATIONS |
(1) FWHM or 50% transmission (2) All Skye sensors will work at levels of irradiance well above that found in terrestrial sunlight conditions, room or growth chamber lighting (3) Main source of this error is uncertainty of calibration of Reference Lamp. Skye calibration standards are directly traceable to N.P.L. standard references. (4) Cosine error to 80deg is typically 5% max. Figures shown are for normal use sources, e.g., sun plus sky, diffuse sun, growth chambers, etc. (5) Measured at 45deg elevation over 360deg (6) Maximum change in one year. Calibration check recommended at least every two years. Experience has shown that changes are typically much less than figures quoted (7) Times are generally less than the figure quoted, which is in nanoseconds. They may be slightly increased if long leads are fitted, or those of a higher capacity cable |
UV-I (280nm-315nm, 紫外線指数, Erythema 紅はん),
波長応答および仕様
UV-I(280nm-315nm, 紫外線指数)用センサー形状および波長応答
(写真および画像をクリックすると拡大します)
SPECIFICATIONS | |
Dimensions | phi 34 x 69 mm |
Weight | 200g (with 3m cable) |
Construction | Anodised black aluminium sealed to IP68 Submersible to 4m |
Cable | Screened cable 7-1-4C miiltary specification |
Sensor | Cosine corrected head Specially formulated diffuser |
Detector | Filtered TiO Photodetector |
Filters | - |
Spectral response | 280nm-315nm, Erythema |
Working range (1) | n/a |
Output signal | 0-1V |
Sensitivity | 33mV/UVI or 1.32V/W/m2 |
Thermal drift of output (-20 to +50 deg C) | 0.075mV/deg C max |
Zero offset range (each sensor is individually calibrated) |
+/-1 mV |
Thermal drift of zero offset (-20deg C to +50deg C) |
typically 0.03 mV/deg C |
Ouput impedance | 500 ohm |
Power supply | 5-15V |
Linearity (0-1V with 9V power supply) | Better than 1% |
Absolute calibration error (2) | typ. <3%, 5% max. |
Cosine error (3) | 3% |
Azimuth error (4) | <1% |
Temperature coefficient | +/-0.2%/deg C |
Longterm stability (6) | +/-2% |
Response time (6) | Better than 50ms |
Operating range | -30 to +60deg C, 0-100% RH |
NOTES ON SPECIFICATIONS |
(1) All Skye sensors will work at levels of irradiance well above that
found in terrestrial sunlight conditions, room or growth chamber lighting (2) Main source of this error is uncertainty of calibration of Reference Lamp. Skye calibration standards are directly traceable to N.P.L. standard references. (3) Cosine error to 80deg is typically 5% max. Figures shown are for normal use sources, e.g., sun plus sky, diffuse sun, growth chambers, etc. (4) Measured at 45deg elevation over 360deg (5) Maximum change in one year. Calibration check recommended at least every two years. Experience has shown that changes are typically much less than figures quoted (6) Times are generally less than the figure quoted, which is in nanoseconds. They may be slightly increased if long leads are fitted, or those of a higher capacity cable |
Meter仕様, SpectroSense2+, SpectroSense2, Apollo
Meter | SpectroSense2+ | SpectroSense2 | Apollo |
Sensor input(s) | Choose 8 inputs from 8x current, and/or 4x voltage |
Choose 4 inputs from 4x current, and/or 2x voltage |
1 channel voltage |
Connector(s) | Binder Sub-miniature, 5 or 8 pn for sensors 8 pin for PC connection |
Binder Sub-miniature, 5 or 8 pn for sensors |
5 pin binder Pannel-mounted socket |
Display | 20x4 line, alphanumeric LCD | 14 character x 2 line LCD |
|
Input range | Current ranges +/-20nA to +/-2mA Voltage Ranges +/-2mW to +/-2V |
1channel Voltage (0-2V standard) |
|
Resolution, Accuracy |
Resolution: Minimum 16 bit, 1 part in 65536 Accuracy: Typically 0.008% at 20 deg C for mid-range |
Resolution: 20 bit 'A/D converter' Accuracy: Typically 0.008% at 20 deg C |
|
Memory | Sensor library for 16 calibration factors Non volatile EEPROM memory, no data loss if main power fails Over 2000 readings of each 8 inputs stored with date and time |
Sensor library for 16 calibration factors Non volatile EEPROM memory, no data loss if main power fails |
None |
Clock | Real time clock powered by internal Li battery, ability to synchronise reading between several SpecroSense2+ meters Will keep time without the main batteries |
None | None |
Logging intervals | 1, 2, 5, 10, 20, 30 [sec.] 1, 2, 5, 10, 20, 30 [min.] 1, 2 [hours] Intervals > 10s will be averages of 10s readings |
Logging function not available | Logging function not available |
Modes | A) 4 or 8 sensor/channle display B) 2 or 4 ratios display C) Intergation display D) Set up mode E) F1 "favourite" display F) NDVI display G) Log mode H) Memory functions J) Download to PC |
A) 4 sensor/channle display B) 2 ratios display C) Intergation display D) Set up mode |
Read sensor, hold display, toggle units (e.g.Wm2, mWm2, UVI units etc.), battery test |
Power | Internal 9 volt PP3/MN1064/6LF22 battery External 12VDC power supply via RS232C socket, from solar power, mains tranformer or vehicle |
1x 9V PP3 battery | |
Battery life | 40-50 hours in display mode, up to 300 hours in log mode |
40-50 hours in display mode | Up to 14 hours use |
Dimensions | 200(W)x150(H)x70(D)mm | 88(W)x139(H)x28(D)mm | |
Construction | Black ABS, sealed to IP54 | Black ABS, splashproof | |
Keypad | Membrane keypad, audible key press, 12 keys | Membrane keypad, audible key press, 8 keys | 6 keys |
Weight | 700g | 290g | |
Operating range | -20 deg C to +70 deg C 0-100% RH |
-20 deg C to +70 deg C 0-100% RH |
左上:Apollo, 右上:SpectroSense2
(SpectroSense2+の写真は準備中です)
※ 仕様・納期・価格等については弊社までお気軽にお問い合わせください。
※ また, このHPに紹介されている製品以外で, 取り扱い可能な製品もございます。
詳細は弊社までお問い合わせください。